DC_GUI: Starting DC_Gui

Previous | Table of Contents | Next

## Starting DC_Gui

You can start DC_Gui by entering the following command to the command line:

# dc_gui &

Note: # is the command prompt, don't enter this.

After entering the command, the following screen will appear.

As you see, the screen is devided into three major parts:
1) The 2D tabs part, the upper left part.
2) The Nickname list part, to the right of the 2D tabs part.
and
3) The transfer part, at the bottom of the window.

Note: the first time you start DC_Gui, you might need to adjust the size of the parts (Drag down the bar that spits the upper and lower part).